Shunt Load Heating Element - 1.5 Ohms - 2" BSP Thread

Product discontinued


Shunt Load Element - water immersion heater

This low-voltage water-heating element is for use as diversion loads for wind or hydroelectric systems. Use one or more of these heating elements with a regulator capable of load diversion, such as the Plasmatronics PL series or the Outback FlexMax series to turn your excess power into hot water.

The element has a standard 2 inch parallel BSP thread found on some hot water systems or 200 Litre drums and is fitted with a two-metre insulated lead. Depending on voltage and desired amp draw, two of these elements can be wired in series or parallel.

The resistance is 1.5 Ohms allowing it to be used for 12 Volt or 24 volt system voltages by series or parallel element connections. The combinations are ideally suited to the load capacity of the PL20 regulator (20 Amps), PL60 (30 Amps) or Solid-state relays, RGX-R41-1 (40 Amps). If the PL40 is used, a relay would be needed to operate off the 5A load terminal.

The element length is approximately 500 mm.

20A @ 30V when used individually (1.5 Ohm)
For further characteristics and instructions download the RGX-E15 spec sheet.

Not suitable for 48 Volt systems.

Weight: 0.7 Kilograms
Warranty: 12 mths


Related Products

No related products.

We install solar systems in Northern NSW and Southern QLD.

Gold Coast (from Coolangatta to Southport), Nerang and Hinterland (Beaudesert) and out West (Warwick, Stanthorpe, Killarney)

Northern NSW (Tweed Heads to Yamba, including Evans Head, Byron Bay and Ballina); the Far North Coast Hinterland (Grafton via Lismore to Murwillumbah) and out West (Casino to Tenterfield, including Drake and Tabulam, as well as Woodenbong and Bonalbo)

For larger system we also go up to Brisbane or down to Coffs Harbour and even Glen Innes. Other places by arrangement.

Tesla Powerwall now in stock!

Rainbow Power Company is pleased to announce that Tesla Powerwall Home Batteries are now in stock - ready to be installed.

Tesla Powerwall is the most cost effective and innovative grid-storage battery on the market and can be retrofit to most existing solar systems.

Contact us NOW

It may sound like a dull sales slogan but stock is limited and moving out fast.

Contact us today for an obligation free quote.